91热爆

Introduction to electromagnetism

Key points

  • An electromagnet uses an electrical current to generate a magnetic field.

  • There are three ways to strengthen an electromagnet:

    • increasing current

    • increasing the number of turns of the coil

    • adding an iron core

  • An electromagnet with a permanent magnet can be used to make motors and loudspeakers.

Game - electromagnets

Play an Atomic Labs experiment exploring electromagnets.

You can also play the full game

Back to top

Electromagnetism

A video about electromagnetism

A video that shows how electromagnets work

Any wire with current flowing through it has a . Most of the time the magnetic field is too small to be important or have any noticeable effect.

The magnetic field lines around a current-carrying wire are circular. The field lines are closer together near the wire. This shows that the magnetic field is stronger when close to the wire.

Concentric circles representing the magnetic field around a wire with a current flowing through it.
Figure caption,
Any wire with current flowing through it has a magnetic field

A coil of wire with many turns is called a .

The shape of the magnetic field around a current-carrying solenoid is like the magnetic field pattern of a bar magnet.

A coil of wire with many turns (a solenoid) on the left hand side. A bar magnetic on the right hand side. Both have identical magnetic fields.
Figure caption,
A current-carrying solenoid and a bar magnet have identical magnetic fields

If the magnetic field becomes strong enough to be useful, it is called an electromagnet.

A typical electromagnet consists of a wire coiled around an iron core.

The iron core is often called a soft iron core. This is because iron is magnetically soft. This means the iron core is easy to magnetise and easy to demagnetise.

A coil of wire around a soft iron core. This creates an electromagnet.
Figure caption,
A typical electromagnet consists of a wire coiled around an iron core
A Maglev train which is held up and controlled by electromagnets
Image caption,
This Maglev train is held up and controlled by electromagnets.

Electromagnets are used in automatic door locks, headphones, scrap yard cranes and even to make magnetic, levitating trains.

A Maglev train which is held up and controlled by electromagnets
Image caption,
This Maglev train is held up and controlled by electromagnets.
A crane picking up disposed materials
Image caption,
The driver of this crane is able to switch the electromagnet on and off to pick up and drop magnetic materials.

Electromagnets can be switched on and off. They are only magnets while current is flowing though the coil. Electromagnets can be made stronger or weaker.

A crane picking up disposed materials
Image caption,
The driver of this crane is able to switch the electromagnet on and off to pick up and drop magnetic materials.
Back to top

Increasing the strength of the electromagnet

There are three main ways to increase the strength of an .

  1. Using more turns on the coil of wire will produce a stronger magnetic field.

Coiling up a longer piece of wire adds up the magnetic field of each turn.

Two batteries. One is attached to nail with a wire round it with a few turns. The nail picks up 2 paperclips. The other is attached to a nail with more turns around it. 4 nails are picked up.
Figure caption,
Increasing the current through the wire creates a greater current which will produce a stronger magnetic field
  1. A greater current will produce a stronger magnetic field.
2 batteries attached to a nail with wire coiled around it. The nail picks up 8 paperclips. One battery is attached to a nail with wire coiled around it. The nail picks up 4 paperclips.
Figure caption,
The current in the wire produces a magnetic field and a greater current will produce a greater field
  1. Adding a soft increases the strength of an electromagnet.

Iron is a magnetic material. A coil of wire is wrapped around an iron core. The iron core becomes magnetised when the electromagnet is switched on. This increases the overall strength of the electromagnet.

Two batteries. One is attached to a coil of wire and piiks up one paperclip. The other is attached to a nail with a coil of wire around it and picks up 4 paperclips.
Figure caption,
Adding a soft iron core increases the magnetic field strength
Back to top

Try the experiment online

Try out this experiment in Atomic Labs. Go to the Physics lab and try the Electromagnets experiment.

Atomic Labs game. game

Try out practical experiments in this KS3 science game

Atomic Labs game
Back to top

The motor effect

If two of the same (either north with north or south with south) are brought near each other, they push each other away. Like poles repel.

Two bar magnets side by side with the two north poles closest together. Two green arrows between the magnets point in opposite directions indicating two like poles repel each other.

If two opposite poles (north with south) are brought near to each other, they pull towards each other. Un-like poles .

Two bar magnets with the north pole of one and the south of the other closest together. Two green arrows between the magnets point towards each other indicating two different poles attract each other.

Find out more about magnetism in the Magnets and magnetic fields guide.

Knowing that two magnets can or helps us to explain how an electric motor works. In the diagram, Both the permanent magnet and the current-carrying wire have a magnetic field around them. The permanent magnet and the wire exert a force on each other.

An orange line around a permanent magnet represents a wire. The permanent magnet and the wire exert a force on each other.
Figure caption,
Both the permanent magnet and the current-carrying wire have a magnetic field around them

The force on a current-carrying wire near a permanent magnet causes the wire to move. This effect is called the motor effect. This is used in a DC motor.

An force on a permanent magnet causes the wire to move.
Figure caption,
The split ring commutator is a special connector that allows the DC motor to spin in the same direction

1. Looking at the diagram of the split ring commutator, what do you think would happen if you reversed the cell?

2. What do you think would happen if you swapped the poles of the magnet?

Back to top

Electromagnets in headphones and loudspeakers

A person wearing headphones

A device supplies an electrical signal to a coil of wire that is attached to a cone. When current flows one way through the coil, the cone is pushed forward. When current flows in the opposite direction, the cone is pulled backwards. As the current in the coil repeatedly changes direction it makes the cone vibrate. The air vibrates and sound waves travel to our ears.

A person wearing headphones
A coil of wire and a magnet inside a loudspeaker.
Figure caption,
The motor effect is used in loudspeakers
Back to top

Electromagnets in microphones

A person using a microphone

Microphones have a very similar structure to speakers. Both have a coil of wire that is able to move near a permanent magnet.

In the microphone however, incoming sound causes the diaphragm to . This moves the attached coil of wire.

The effect is the opposite of the . The wire moving near the magnet causes an electrical output.

A person using a microphone
Incoming sound causes the diaphragm in a microphone to vibrate. The attached coil of wire moves and causes an electrical output.
Figure caption,
A microphone uses the generator effect
Back to top

Test your knowledge

Quiz

Back to top

Play the Atomic Labs game! game

Try out practical experiments in this KS3 science game.

Play the Atomic Labs game!
Back to top

More on Electromagnetism and magnetism

Find out more by working through a topic