Six-mark questions
Six-mark questions are extended open response questions. These require longer answers than the structured questions with fewer marks. It is wise to plan your answer rather than rushing straight into it, otherwise you may stray away from the key points.
Six-mark questions are marked using a levels-based mark scheme because they are open-ended. To gain full marks, you need to:
- support explanations using scientific knowledge and understanding
- use appropriate scientific words and terms
- write clearly, linking ideas in a logical way
- maintain a sustained line of reasoning, rather than getting lost or bogged down
You are likely to see command words such as:
- 'describe' - you need to give an account but no reason
- 'explain' - you must give reasons or explanations
- 'devise' - you must plan or invent a procedure using your scientific knowledge and understanding
- 'evaluate' - you must review information, including identifying strengths and weaknesses, and make a supported conclusion
Six-mark questions may be synoptic questions. This means they bring together ideas from two or more topics. For example, a question about fertilisers could include ideas about covalent substances, acids and alkalis, chemical calculations, and effects on the environment.
Remember that the topics covered in the first paper are assumed knowledge for the second paper, so questions in the second paper may need knowledge and understanding of those topics too.
The answers shown here give marking points as bullet points. You do not usually need to include all of them to gain six marks, but you do need to write in full sentences, linking them logically and clearly.
Writing six-mark answers with Dr Alex Lathbridge
Listen to the full series on 91热爆 Sounds.
Sample question 1 - Foundation
Question
Ammonium sulfate solution is made by reacting an acid with an alkali in a neutralisation reaction.
Write down the name of the acid and the alkali needed to make ammonium sulfate.
Describe how an indicator can be used to check the pH of the solution made.
[6 marks]
OCR Gateway Science, GCE Chemistry, Paper B741, June 2015.
Acid and alkali:
- sulfuric acid/H2SO4
- ammonia/ammonia solution/ammonium hydroxide/NH3/NH4OH
Checking pH of solution:
- remove a sample, eg on a glass rod
- add to universal indicator solution/paper
- leave 30 s for colour to develop if using paper
- compare the colour obtained against a colour chart
- the colour tells you the pH of the solution
- eg green means pH 7
- eg red/orange/yellow means pH less than 7
- eg blue/purple means pH more than 7
Sample question 2 - Foundation
Question
Copper chloride is prepared by reacting copper carbonate with dilute hydrochloric acid. The copper chloride is formed as an aqueous solution.
Describe an experiment to prepare a pure, dry sample of copper chloride, starting with copper carbonate powder and dilute hydrochloric acid.
[6 marks]
This question has been written by a Bitesize consultant as a suggestion to the type of question that may appear in an exam paper.
Reactants:
- put hydrochloric acid into a suitable container, eg beaker or flask
- add copper carbonate powder
- stir
- continue adding until no more reaction/excess powder left behind
Separating the product:
- filter
- use of filter funnel and paper
Making pure dry salt:
- heat copper chloride solution/filtrate
- evaporate water/crystallisation
- dry crystals in oven/leave to dry/in a warm place